Hello All,
Might be barking up the wrong tree but I'm looking for some direction to get a new Windows 10 Box with integrated parallel port to see an old parallel HASP dongle.
At this point I've installed the software to run our old unsupported router and it installed perfectly on this Windows 10 Pro x32 (ver 1511 build 10586.218) installation. The obvious problem is the software won't run until it see's the dongle.
I have started from the ground up and I can change many aspects of the LPT port in the BIOS (SPP, EPP, ECP - use DMA i/o 0378 default, etc etc) I also have set the hardware within Windows to "Use any interrupt" and "Enable Legacy Plug and Play" and always use the LPT1.
The old installation was Windows XP Pro (x32) and the motherboard is beginning to have hardware issues (so I'm being proactive here)
I haven't been able to see the key yet on this box - I've been playing with multiple drivers and reading up on the fixes that worked for others using Windows 7 re compatibility to no avail.
at this moment I am running:
I have also installed the Sentinel Protection Installer 7.6.8 Windows.
Again this is an old HASP parallel dongle (not USB) Any advice on where to go next?
Thanks in advance.
Cam
Might be barking up the wrong tree but I'm looking for some direction to get a new Windows 10 Box with integrated parallel port to see an old parallel HASP dongle.
At this point I've installed the software to run our old unsupported router and it installed perfectly on this Windows 10 Pro x32 (ver 1511 build 10586.218) installation. The obvious problem is the software won't run until it see's the dongle.
I have started from the ground up and I can change many aspects of the LPT port in the BIOS (SPP, EPP, ECP - use DMA i/o 0378 default, etc etc) I also have set the hardware within Windows to "Use any interrupt" and "Enable Legacy Plug and Play" and always use the LPT1.
The old installation was Windows XP Pro (x32) and the motherboard is beginning to have hardware issues (so I'm being proactive here)
I haven't been able to see the key yet on this box - I've been playing with multiple drivers and reading up on the fixes that worked for others using Windows 7 re compatibility to no avail.
at this moment I am running:
| Run-time Installer | 7.41 |
| Run-time Package | 7.41 |
| hardlock.sys | 3.88 |
| fridge_lib | 1.8 |
| aksfridge.sys | 1.74 |
I have also installed the Sentinel Protection Installer 7.6.8 Windows.
Again this is an old HASP parallel dongle (not USB) Any advice on where to go next?
Thanks in advance.
Cam