Old application using parallel HASP-dongle not working under Win10 1809 32bit

Hi,

I'm still using an old application (2006) that made use of a parallel Aladdin HASP dongle.

Recently I had to re-install my PC and used the new Windows 10 1809-release. Since then I can't get the application running anymore, and this is due to the HASP-key not working.

It used to work under Win_1709, but I had some hassle to get the HASP4-driver installed and had to do it with some tweaks. Now this doesn't work anymore. I've already installed the Sentinel LDK Run-Time & Cmd-Line SW which do install, but still the key is not recognized. Readout of Aladdin Diagnostics 1.10 is attached.

I'm using a PCIe Parallel port extension board.

When trying to install the HASP4 Driver v5.22 with which I could get things running under Win_1709, I now get first an error that the drivers is not suited for this Operating System, and afterwards I get a BSOD. When running WhoCrashed I see that the probable cause was Haspnt.sys.

Attachments:

Under Win_1709:

    "AladdinDiagnostic91 GOOD Redout 1.jpg": HASP key found on local port;
    "AladdinDiagnostic91 GOOD Redout 2.jpg": Details of the port found;
    "Aladdin DiagnostiX110 GOOD System Info Result.jpg": System info gathered via Aladdin Diagnostic 1.10
    "Aladdin DiagnostiX110 GOOD Result.jpg": Result on Aladdin Diagnostics 1.10 HASP page

Under Win_1809:

    "AladdinDiagnostic91 Faulty Redout 2": Details of the Aladdin Diagnostics 9.1 findings;